Setting toner supply on MITA dc 1855

[Transpost1]

Posted by catalin on 10/01/2004
After i cleean the copier I instaled the new developer but I'm stuck on setting toner level and frecvency of adding toner in developing unit.
Please help me guys !!!
Thank you in advance !!!

User "Transpost1" was created to allow us to move posts from one forum to another.

[Transpost1]

Posted by raym on 10/01/2004
hi cat. to get into simulation mode, hit "10871087" then "print". you should see "U00". enter "60" then "print" and it should start running, automatically setting toner density. when it stops, about 2 min. or less, i hit "stop/clear" and then repeat procedure one more time. when finished, hit "stop/clear" twice, you'll see "U00", punch in "01" then "print" to exit. hope this helps. good luck!
Link: service@standard-office.com