copystar 2030

[Transpost1]

Posted by kevin on 10/06/2004
Hey guys, I'm thinking about selling the copystar brand mainly the 2030 model. Just wondering what some of you think about this model that has worked on it from a service standpoint. Thanks for the input.

User "Transpost1" was created to allow us to move posts from one forum to another.

[Transpost1]

Posted by raym on 10/06/2004
i've worked on alot of these models and i definetly give it two thumbs up. a very dependable machine!

[Transpost1]

Posted by Nesbet on 10/07/2004
If the same as KM2030 Kyocera:
Fuser time consuming to work on...
Switchable output section has long term jamming problems due to heat cracking the guide fingers. One way bearing gave trouble, too.
Paper cassettes toy-like.
The rest is OK.
Only one thumb up from me.

[Transpost1]

Posted by Aneurysm on 10/21/2004
Well, the 2030 is a great machine but it has been discontinued and replaced by the km-2050, so far so good.
Link: http://www.copytechnet.com

[Songman0831]

Good machine, but found on one particular unit, using duplexing and RADF, copies are not square. Went through machine, had Copystar tech dealer come in and set it. But 6 months later same problem. Other than that machine I've had good results.

David G. O'Connor