KM-1510 E70 CODE

[t]

THIS ONE IS GIVING ME A JAM E70 CODE EVERY TIME. THERE ISN'T MUCH IN THIS ADF. I GET MY VOLTAGES TO THE SENSORS AND THE SOLENOID IS KICKING ON TO FEED IT THROUGH. THE WIRE HARNESS IS OK TOO. HAPPENS EVERY TIME. ANY IDEAS

[mitatech]

maybe the actuator of the sensor on the adf is not returning to its position after the paper p*ss through it.

[KyoceraPro]

Check the DFTSW (DF timing switch) replace it if one is available and see if that helps.

[t]

REPLACED THE TWO SENSORS IN THE DF AND NO LUCK. THE LEVERS ARE IN PLACE AS WELL. HMMMMMMMMMM?