Results 1 to 4 of 4

Thread: Bizhub C353 error C1183

  1. #1
    I believe it has something to do with the finisher lift up trays...I pulled this out of the fs514 manual code shopuld mean the same for your finisher as well.....Hope this helps
    C1183
    Elevator motor ascent/
    descent drive failure
    The elevator tray lower limit sensor (PC13) is not turned ON
    even after the set period of time has elapsed after the main
    power switch is set to ON.
    The elevator tray home position sensor (PC11) and elevator
    top face detection sensor (PC12) are not turned ON even
    after the set period of time has elapsed after the elevator
    motor (M11) is energized.
    The elevator tray does not stop at the position for the specified
    tray after the elevator motor (M11) is energized (beginning of
    descent operation) and the elevator tray lower limit sensor
    (PC13) is turned ON.
    The elevator top face detection sensor (PC12) is not turned
    ON even after the set period of time has elapsed after the elevator
    motor (M11) is energized (beginning of ascent operation)
    when paper is being fed out.


  2. #2
    New potential customer called with this code. I looked through my other Minolta manuals, but didn't help, and I don't have this one yet. Can someone give definition of this code? TIA.


  3. #3
    Check if the Fs is correct mounted also the bins should mounted correct with screws.
    Check if the black lever actuator moves free


  4. #4
    hI
    yOU NEED TO UPDATE YOUR FS514 FINISHER AND COPIER WITH VER88
    ITS A FIRMWAREUPGRADE JUST FOR THIS ERORR


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •