Results 1 to 2 of 2

Thread: SC441 Error

  1. #1
    Senior Member
    Join Date
    Dec 2004
    Location
    California, USA
    Posts
    690
    Okay, we replaced the DV unit motor assembly, pulled out the DV unit and it doesn't seem to have binds, but we still get SC441 codes. If we run the DV Unit Motor in Service Mode without the DV unit it runs just fine. If we put the DV Unit back in it eventually slows, stops and goes into code. Is there a bind that only happens after a while in the DV unit on these? THIS IS A SAVIN 2070dp ( RICOH 700)

    Any help?

    Thanks

    Kelly


    This message was edited by mrfuser on 8-27-09 @ 5:21 PM

  2. #2
    replace all door switches as a set. If that doesn't work replace the development unit.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •