PDA

View Full Version : Konica 7155 code SC46-08



kalindd
07-02-2006, 09:34 PM
I went to replace the drum because of a little bit of a gray background. So I replaced it and ran all "Drum Peculiarity Adjustment", after that same thing with the background. So I started to change settings in DIP switches. Also I cleaned the "dust proof gl*ss" (I dont remember wich one was first), and all of a sudden this code comes up. I've checked the write unit seems OK. Today I entered all initial values in DIP switches, same code. Any suggestions?

alexxcopier
07-13-2006, 08:57 PM
try to find the fifth pin conector from home position of writing unit and pull out from the main board
when u find the right connector restore all the data to default and everything will be Ok

This message was edited by alexxcopier on 7-14-06 @ 9:06 AM