View Full Version : Di250f print not built in

11-23-2007, 08:55 PM
not familiar with Minolta but it has the R45 green light and parallel connection on the back and it still says "PC Printer not built in" is there software i need????

You wanna talk about old school
haven't see Minolta since the 450
not Rhetorical lol


11-24-2007, 07:09 PM
Yes, there is software. I'll have to look to see if I still have it. That series of machines were actually pretty good, easy enough to work on if you know minolta. Print systems were another story, though. Too many problems, error codes, & difficult to install. I still sell these but never with print systems, I just pull them if installed & set them aside. If they need printing, they either have to buy new with embedded print systems or I'll just give them a good used hp laserjet 4+.

11-25-2007, 08:19 PM
i think that you don,t have the cable installed the cable is between the controller and the engine it's connected at back it's a centronics type and is going to horizontal part of the machine please check it let me now if this is missing you can check in the display if the controlle is alive