PDA

View Full Version : PI5501 problem



off123
01-06-2008, 07:01 PM
Hi All, i have one DI550 with internal print option PI5501 and have one problem.I don't know IP of the machine.I know that when machine warming first copy is cpnfiguration protokol of fiery, but someone disable this option.Please give me some idea how to find IP adress.Regards

T.selex
01-07-2008, 06:47 PM
Hi
Open back the Pi5501 and reset it to the factory default.
Resetting to Factory Defaults:
Jumper switch OP2 can be used to reset all Network Card parameters to their initial factory default settings.
Network Card Reset Procedure:
1. Power down the Copier and unplug it from its power outlet.
2. Disconnect the network cable from the Network Card.
3. Remove the Network Card from the printer by performing the steps in Setup Instructions in reverse.
4. Locate the reset jumper switch (labeled OP2) on the Network.
5. Change the OP2 jumper switch to its FACT position (OP2 set to pins 1 and 2).
6.re-install the Network Card. Do not connect the network cable at this time.
7. Plug in the Copier and power it up.
The Network Card performs a self-test, indicated by the green LED flashing three times, following by the green LED and amber LED flashing alternately. After the green and amber LEDs start to flash, power down the Copier and unplug it from its power outlet.
8. Remove the Network Card from the Digital Copier again.
9. Return the OP2 jumper switch to pins 2 and 3.
Now you can have the configuration page with the IP address.
Good luck-tolis GR

off123
01-12-2008, 05:51 PM
Thank you, working.