PDA

View Full Version : Konica 1015



chuckt528
03-27-2008, 07:36 PM
Does anyone know the procedure for drum & dv repl. on
a Konica 1015? Thanks

bushy
03-29-2008, 08:37 PM
just change drum and blade as with any other m/c but with dev b4 you start reset pm counter 47-90 print do dev change then do 47-51 let m/c cycle until it stops turn m/c off/on and your all done

bushy

chuckt528
03-30-2008, 06:53 PM
Thanks Bushy, big help. One other thing, how do I get into maint. mode? Thanks again.

bushy
03-30-2008, 08:35 PM
turn m/c off hold down 4 & 7 keys whilst turning m/c on
dial in 90 press print and counter is re set
do same 4 & 7 to enter the dev set up but this time 51 print and allow to run until it finishes its set up
it should display 51 in window on completion of setup
all your test modes are in 4 7 mode and your adj. are in 3 6 mode your defaults and over heat reset are in 2 5 mode

bushy

chuckt528
03-31-2008, 07:13 PM
Thanks