View Full Version : Sharp AR-207

06-01-2010, 10:15 PM
Just replaced the Laser unit: L6-10 code, reassembled and now I have a F5-02 code which refers to a lamp problem ?? the lamp lights and the optics seek home position ... the odd thing is that the scanner goes back and forth rapidly near the scale plate almost like a chatter !!

Checked the connections to the Lamp and the scanner motor ... including double checking other connections, removing the lamp connector at the main board gives an F5 without the chatter ???

Any help appreciated ... Thanks, Mike

06-08-2010, 09:15 PM
Hi,try cleaning thoroughly white strip attached to
underside of glass at leading edge.Exposure lamp and
lenses.reassemble and try again.Hope this helps,Tech
from the UK.World cup match/soccer on sat*rday,
England v Usa may the best team win.

06-08-2010, 09:52 PM
Thought I had posted what I found wrong ...

There was a bad connection at the CCD cable where it plugs into the MCB !! thought I had seated it thoroughly ... apparently these are rather touchy.

Thanks for the help