Search:

Type: Posts; User: Gule

Search: Search took 0.05 seconds.

  1. Thread: c450

    by Gule
    Replies
    2
    Views
    1,525

    Katun provides IU reset chips. There are...

    Katun provides IU reset chips. There are equipment for sale that can be used to reset the IU:s aswell.
  2. Replies
    1
    Views
    5,342

    Might be the customer running thicker paper stock...

    Might be the customer running thicker paper stock with tray paper type setting as normal.
  3. Thread: Sharp MX2300

    by Gule
    Replies
    2
    Views
    4,445

    Replace or try to clean the chargers. In humid...

    Replace or try to clean the chargers. In humid environments they tend to oxidize.
  4. Replies
    3
    Views
    1,002

    Problem solved. Replaced HV PWB.

    Problem solved.
    Replaced HV PWB.
  5. Thread: SHARP SD2060

    by Gule
    Replies
    3
    Views
    922

    Check the main corona output for short. Check...

    Check the main corona output for short.
    Check the high voltage trouble signal.
    Check and adjust main corona voltage.
    Then reset with SIM14.
  6. Replies
    3
    Views
    1,002

    One of my customers has a DSc428 which leaks...

    One of my customers has a DSc428 which leaks black developer. The experienced problem is faint images. This is due to low amount of developer in the DV unit. The machine then cannot sense correct TD...
  7. Replies
    3
    Views
    1,308

    One of my customers are asking for some kind of...

    One of my customers are asking for some kind of software that can convert address book information from MS Outlook (w/o an Exchange server/LDAP support) to proper .csv files for use in...
  8. Thread: AR-336/AR-RF1

    by Gule
    Replies
    3
    Views
    1,031

    Clean all optical sensors and run sim 53-2 to get...

    Clean all optical sensors and run sim 53-2 to get new values. Adjust springs on roller on left door. Replace separation pad.
  9. Replies
    1
    Views
    811

    Might be due to faulty DM gain and ID...

    Might be due to faulty DM gain and ID sensitivity. Check sim 44-02 and 44-03 and adjust with VR1 and VR2 to 204 (+-10V).

    HV board could also be NG.

    Damaged/very worn OPC can cause this too.
Results 1 to 9 of 9