Search:

I don't need it now. I was able to get it from my Kyocera site. Thanks

Anyone have a copy of Kyocera ecosys M2450 service manual?

Have a machine that will FAX, but sometimes will give a F375 error, a 33C error and a F245 error.
Anyone have any other ideas or the firmware? Thanks

Copier will print status, menu map etc. But when you go to copy, the paper feeds and it doesn't begin to feed paper but gives error F33C

I mistyped the code in the post header. I went and pulled...

You have a bad developer. Seen it many times. Looking at a ecosys 2535 that does it right now. Had one last week.

I have a Okidata MC361 in the shop. It has paper feed problems from the bottom tray. I have tried rollers, drawers etc. Works flawlessly through the bypass. Made 400 copies without jam through the MP...

The USB drive slot doesn't work, so can't update the firmware. Must be problems on the main board.

I have the firmware, it was on my other PC, just can't reload it. Thanks for looking at it.

I have a customers Kyocera in the shop that lost the FAX capability. It doesn't select. Tried a new card under warranty and it didn't find it either.
Tried service mode and there are no FAX...

Customers machine has an Alarm light. Then a message about "Supply Rec. Paper Tray 1". Paper tray is full. However when trying to feed through the bypass it sounds like it is locked up. Any...

How do I initialize the developer after I replace it, and are there any other problems That I might be overlooking on this analog machine?

What is it and what's most likely the problem? I don't have this particular service manual

Contact Carolina Wholesale. There is some training involved and testing.

I don't have the service manual for this model. I need to replace the paper feed roller. Is this an easy job? I've heard from parts rep that these things are flying out of their stores.

Thanks for your answer. I knew that the thin side had caused the previous roller to contact the thermostat and rub the film off. However, after mic'ing the new roller shaft and the old there was a...

One end of the fuser bearing is thicker than than the other, possibly to keep the roller away from the thermostat. Which side goes toward the thermostat, thick or thin. I don't have a manual for...

Have a Mita KM3530 that will make normal copies and suddenly changes to all black copies with no text visible. Is this the Laser going bad or what?

We located it. No problem.

Where is it located and what is the part number.

I've seen Doctor blades mis-adjusted and they would let too much toner over the top and slip through, dumping on the ends of the corona wire. I'd guage it with Paper shims to be sure.

I want to disconnect the sorter from the main unit and disable the sorter while I repair the copier.

What is the correct procedure to enter service mode and then disable the sorter?

We found the problem after a while.
Finally determined the paper wasn't going through the fuser in the center but over on the edge. Looking further led to a broken part in the paper tray. ...

We recently did Maintenance on this KM3530 Mita, replacing many parts. New fuser, New transfer Roller and new Exit Rollers with shafts. Occ*ssionally it still jams at entrance of Paper Exit...

Have a Xerox XD130df in the shop. works ok for a while, then casts toner below

Thanks for the additional info. I had manual on Ricoh Ft 5840 but not the sorter unit. I plan on going over to check it next week. Thanks Derek

Actually I'm not sure. It's a Savin 900D. I believe it is a ST26 sorter. The paper doesn't finish exiting the fuser and the error is Paper path. Can I remove the sorter *ssembly on this and then...