Search:

no what really happens is factory uses too much starting powder at install that eventually fries into the grid but I will bet your problem is old supplies

not looking in my SM but off the top of my head. h4 02 is a specific heat lamp low temp signal. First thing is set all heat temp values back to factory defaults. Sharp always run best there . Don't...

what is the jam code in tc22-3? that's how you start

sounds like the problem is the port you moved it to . is it a managed port? Why on earth would you think its the copier? The 3100 nic is built into the mfp controller pwb. did you have a short...

big thing on sharps 1st digital 9 years old!!!! is it was built on the 2000 frame .the 2000 had drive problems so they split the drive in 2. Now separate motors.Not having the old service man.(we...

wake up mcfly...absolutly there is a firey .....on the back of a 507 why do you think there's port a and b go into tc26 44 and you can select either port.infact in my sharp controller class we had a...

humb ya this is the scoop! probly hdd or ic 22 on ICUpwb under the hdd.Somtime they get so hosed up you have to relace icu pcu all flash roms and ic 22(nvram)at once. circling stars?does'nt...

lucy first you said something bizare,always say lead edge,trail edge,front frame,or rear frame then it is very clear as to logistics. also I've worked at a sharp dealer for 28 years and on the c 330...