Thanks Thanks:  0
Likes Likes:  0
Results 1 to 7 of 7
  1. #1
    Junior Member
    Join Date
    Aug 2009
    Posts
    1
    Post Thanks / Like

    Hi all
    Have E-Studio 16s with 3 lines on copies
    Have replace the cleaning blade but has made no difference.
    Clean the laser glass,clean charge crona.
    None of the above change anything.
    Any ideas on where to go next?


  2. #2
    Junior Member
    Join Date
    Aug 2009
    Posts
    5
    Post Thanks / Like
    replace or clean the transfer wires. Also check the fuser hot roller for marks where stripper fingers ride on.


  3. #3
    Senior Member
    Join Date
    Dec 2005
    Location
    Wpg. Mb. Canada
    Posts
    184
    Post Thanks / Like
    are the lines there when u do a test print or copy only?


  4. #4
    Member
    Join Date
    Nov 2004
    Posts
    35
    Post Thanks / Like
    Try optics and ADF scan galss...??

    Stop a copy half way through it's run and that way you can see if on your image area or heat area has the fault.

    Try enlarge/reduction copies...maybe on the mirror....?


  5. #5
    Member
    Join Date
    May 2007
    Posts
    45
    Post Thanks / Like
    If the lines are in random locations it could be one of the screws that holds on the toner drive bracket to the plastic main drive frame was relpaced with one that was to long this causes a short to the main charge connection track that runs along the rear side of the main drive plastic frame


  6. #6
    Member
    Join Date
    May 2006
    Location
    Athens GREECE
    Posts
    55
    Post Thanks / Like
    If lines are white dissasemble image unit and check developer material on magnetic roller to see if there are any clogged areas on it.Good luck.


  7. #7
    Junior Member
    Join Date
    Aug 2005
    Posts
    12
    Post Thanks / Like
    you have white line or blak line


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •